LAMMPS WWW Site - LAMMPS Documentation - LAMMPS Mailing List Archives
Re: [lammps-users] Write the data.lammps only of a group ?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [lammps-users] Write the data.lammps only of a group ?

From: Axel Kohlmeyer <akohlmey@...24...>
Date: Wed, 25 Apr 2018 05:42:49 -0400

On Wed, Apr 25, 2018 at 3:23 AM, Siva Chari <ssnchari.hcu@...24...> wrote:
> Hello Lammps users,
> I need a clarification on the following.
> Can we write the data of only a particular group of the total system?


> usually, write_data command writes for the full system, can we specify the
> group keyword here? if so, how?

you cannot.

> I searched in the lammps documentation, but could not get it from there.

that is the rule: if it is not mentioned in the documentation, then a
feature is not available.


> Thanks for your time.
> regards,
> Siva
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites,!
> _______________________________________________
> lammps-users mailing list

Dr. Axel Kohlmeyer  akohlmey@...24...
College of Science & Technology, Temple University, Philadelphia PA, USA
International Centre for Theoretical Physics, Trieste. Italy.