LAMMPS WWW Site - LAMMPS Documentation - LAMMPS Mailing List Archives
Re: [lammps-users] read data file(production) with velocity information
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [lammps-users] read data file(production) with velocity information

From: ‪Ali Khodadadi‬ ‪ <alikhodadadi90@...16...>
Date: Fri, 10 Nov 2017 12:51:18 +0000 (UTC)

I did this and there is no problem if you delete the velocity command and use the saved velocity. 
I saved a custom file in equilbrium simulation and used it for NEMD case. 
Ali Khodadadi (MSC)
School of Mechanical Engineering
Sharif University of Technology
Tehran, Iran.
Email: khodadadi_ali@...7217...

From: liyi bai <liyibai2011@...24...>
Sent: Friday, 10 November 2017, 16:06:18
Subject: [lammps-users] read data file(production) with velocity information


If I read data file with velocity information,do I need assign velocity by velocity again?

Initially, I assign velocity to run for equilibrium and got data file.After that ,I wanna use this data file to run another input script file.Here the data file include velocity information.
I am thinking two ways to deal with it.One is delete the velocity information in the product data and assign velocity again,another is not delete velocity information and NOT assign velocity again.

Could you give me some suggestions which is better?

Thank you in advance~

Best Regards

Check out the vibrant tech community on one of the world's most
engaging tech sites,!
lammps-users mailing list