LAMMPS WWW Site - LAMMPS Documentation - LAMMPS Mailing List Archives
Re: [lammps-users] crystal vibrates widely in NVT and NPT
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [lammps-users] crystal vibrates widely in NVT and NPT


From: Stefan Paquay <stefanpaquay@...24...>
Date: Wed, 30 Aug 2017 10:13:10 -0400

If your time step is 0.2 fs there's no way a damping time of 0.2 fs will work for the thermostat, let alone the barostat. The typical guideline is a damping time of 100 × time step size for the thermostat and 1000 × time step size for the barostat, though your mileage may vary. 

On Aug 30, 2017 5:35 AM, "ruiyan" <r-yan14@...61...> wrote:
Dear all,

I try to get a well equilibriated Al2O3 crystal at high temperature using comb3 potential. Timestep in my simulation is 0.2 fs. I started from 300K with fix nvt command:

fix       3       all         nvt     temp    300   300    0.02      

run      500000

I found that the crystal began to vibrate from about 250000 step, but the vibration was not severe. Then I swithched to npt ensemble and heated the crystal from 300K to 600K with the following command:

fix       3       all         npt     temp    300   600    0.02      aniso    0.0    0.0     0.2   

run      500000

During this process, the vibration became very obvious. What causes this vibration? Could you give me some suggestions on how to reduce the vibration? 

Thanks.

Rui 

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
lammps-users mailing list
lammps-users@...6297....sourceforge.net
https://lists.sourceforge.net/lists/listinfo/lammps-users